CFD Online Discussion Forums

CFD Online Discussion Forums (
-   CFX (
-   -   problem in pressure gradient plot (

kmgraju March 10, 2013 11:24

problem in pressure gradient plot
Dear friends
I use sweep mesh in my model.
I have completed transient analysis with one dimensional interpolation data with repeated cycles.

I run steady state first and then transient.

in the steady state I set pressure value 100 mm Hg at the inlet and I set 0 Pa at the outlet and then I started the transient simulation with one dimensional velocity function as inlet and pressure 0 pa at the outlet.

I checked in the CFX post I could not find any pressure contour and cannot get pressure gradient along the length of the pipe

Kindly point out my mistakes.

ghorrocks March 10, 2013 17:52

Can you post an image of what you do get?

All times are GMT -4. The time now is 09:50.