CFD Online Discussion Forums

CFD Online Discussion Forums (
-   CFX (
-   -   Help me (

Zero September 29, 2013 08:54

Help me
Hello Guys,

I have some problem with modelling ansys cfx 13. I make a pipe 3d (with material water) and i put a
small cube (Solid) inside that pipeline. I have followed the instruction step by step, starting from geometry, mesh, set-up, solution, until result.

My problem is on stage at the result or when running commands streamlined, fluid flow was not flowing through the current splitting cube which resides in the pipeline but the stream directly penetrate the cube.

:confused: So anyone know what, if there is a step or menu commands that may be run first ? Or perhaps on the order set-up there is a command that must be done first !

If anyone ever encountered and who understand how settlement instructions please.. Thank you... :)

oj.bulmer September 30, 2013 09:40

Can you post some images?

All times are GMT -4. The time now is 21:14.