|
[Sponsors] |
Volume fraction correction exponent / Grace Model |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Mathieu
Join Date: Oct 2013
Location: Sherbrooke
Posts: 8
Rep Power: 13 ![]() |
Hi guys,
I have a simulation of multiphase flow (Water flow in a conduct with air injection by a hydrofoil place in the middle) and I use the grace drag model. I inject 1mm bubbles diameter. I notice that the volume fraction correction exponent have influence on my solution (Crash or not ![]() ![]() Thank you ![]() Math |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
Gert-Jan
Join Date: Oct 2012
Location: Europe
Posts: 1,971
Rep Power: 28 ![]() |
I would like to raise this question again.
Mathieu, did you (or someone else) find anything on this topic? I am desperately looking for it. |
|
![]() |
![]() |
![]() |
Tags |
correction exponent, grace, multiphase flow, volume fraction |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
Simulation of a single bubble with a VOF-method | Suzzn | CFX | 21 | January 29, 2018 00:58 |
alphaEqn.H in twoPhaseEulerFoam | cheng1988sjtu | OpenFOAM Bugs | 15 | May 1, 2016 16:12 |
Difference between Volume Fraction and Mass Fraction in CEL | foo7 | CFX | 0 | September 21, 2011 08:45 |