|November 20, 2013, 23:23||
phase change problem
Join Date: Oct 2013
Posts: 9Rep Power: 5
I want to simulate a subcooled boiling problem. the physical condition as follows:
circular tube : length 2m,diameter:0.0154m,pressure:4.5MPa,uniform wall heat flux :570000. inlet velocity :1m/s. After set up all the parameters ,there some mistakes: "While evaluating Fluid 1.Local Speed of Sound, |
Absolute Pressure went outside of its upper limit. Its maximum value was 4.5134E+06. The bounds error was handled by clipping. |
If this situation persists, consider increasing the table range"
WHO knows how to deal with this problem? thank you a lot!!!
|November 21, 2013, 05:09||
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 13,081Rep Power: 101
Firstly, check what is the correct pressure range for this simulation. What is the maximum pressure anywhere? Then set the upper pressure limit for the speed of sound in the material property to this value * 150% to give you some clearance.
If you still get it then your simulation is not numerically stable. This is similar to the overflow error issue and there is an FAQ on that: http://www.cfd-online.com/Wiki/Ansys...do_about_it.3F
|Thread||Thread Starter||Forum||Replies||Last Post|
|simulation of phase change material melting||rosol||FLUENT||4||December 8, 2015 08:56|
|Solid/liquid phase change using large viscosity||gregor.vidmar153||OpenFOAM Running, Solving & CFD||3||June 10, 2010 06:31|
|Two phase flow with phase change||Ahmad Al-Zoubi||CFX||1||November 26, 2008 04:59|
|How to model the solid-fluid phase change in CFX||ohrmond||CFX||2||May 26, 2006 06:27|
|Phase change process||Sang-jin Lee||CD-adapco||5||December 5, 2001 06:17|