Residual plot for transitional turbulence model in CFX-solver manager

ttu004 · March 22, 2014, 02:26

Hi all

I am simulating flow over an aerofoil w.r.t time using SST Gamma-theta model. I noticed that in CFX solver manager, plots (RMS Intermit and Rethetat) for transitional turbulence fluctuate a lot when compare to the Turbulence (KO-K-TurbKE, RMS O-TurbFreq ) residual plot.

My questions are
1. What are the meanings of these plots?
2. With the transitional turbulence RMS plot fluctuates vertically in a wider range than the Turbulence RMS plot, is my results stable and promising?

Thanks
Tom

ghorrocks · March 22, 2014, 05:36

The fluctuations are probably a laminar separation bubble jiggling about. This is a real effect and the transitional turbulence model also shows this jiggling.

So this effect MIGHT be real. Do a sensitivity study to convince yourself.

March 22, 2014, 02:26	Residual plot for transitional turbulence model in CFX-solver manager	#1
ttu004 New Member Tom Join Date: Oct 2013 Location: Auckland, New Zealand Posts: 24 Rep Power: 11	Hi all I am simulating flow over an aerofoil w.r.t time using SST Gamma-theta model. I noticed that in CFX solver manager, plots (RMS Intermit and Rethetat) for transitional turbulence fluctuate a lot when compare to the Turbulence (KO-K-TurbKE, RMS O-TurbFreq ) residual plot. My questions are 1. What are the meanings of these plots? 2. With the transitional turbulence RMS plot fluctuates vertically in a wider range than the Turbulence RMS plot, is my results stable and promising? Thanks Tom

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
transsonic nozzle with rhoSimpleFoam	Unseen	OpenFOAM Running, Solving & CFD	8	July 1, 2022 07:54
rhoSimplecFoam Mach0.8 no pressure values	CFDnewbie147	OpenFOAM Running, Solving & CFD	16	November 23, 2013 06:58
Interfoam blows on parallel run	danvica	OpenFOAM Running, Solving & CFD	16	December 22, 2012 03:09
Differences between serial and parallel runs	carsten	OpenFOAM Bugs	11	September 12, 2008 12:16
Unknown error	sivakumar	OpenFOAM Pre-Processing	9	September 9, 2008 13:53

March 22, 2014, 05:36		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,269 Rep Power: 136	The fluctuations are probably a laminar separation bubble jiggling about. This is a real effect and the transitional turbulence model also shows this jiggling. So this effect MIGHT be real. Do a sensitivity study to convince yourself.