Melting in ANSYS CFX

madfan123 · April 2, 2014, 10:14

Hello everyone! I will try to explain the problem.

On the edge of the metal part, having a burr as a rectangular protrusion, acts heat flux with a high density (about 10e8 W/m2).

111111111111111111.jpg

Necessary to determine the time during which this burr melted. How using ANSYS CFX implement the phase transition from solid to liquid to allow for a gradual change in the geometry of the burr during melting, ie border, on which acts the heat flux? What happens to the fused metal in this problem is not considered.

ghorrocks · April 2, 2014, 18:19

CFX is a CFD solver, not a solid mechanics solver. Try ANSYS mechanical for that. In fact if the heat flux is constant then there is no fluids or heat transfer conponent to this so no reason to use a CFD software. So this model should be done entirely in FEA.

Depending on what the material is you might also need to include phase transitions and that sort of stuff to be accurate - but that depends on how accurate you want to be.

April 2, 2014, 10:14	Melting in ANSYS CFX	#1
madfan123 New Member Jack Join Date: Sep 2012 Posts: 10 Rep Power: 13	Hello everyone! I will try to explain the problem. On the edge of the metal part, having a burr as a rectangular protrusion, acts heat flux with a high density (about 10e8 W/m2). 111111111111111111.jpg Necessary to determine the time during which this burr melted. How using ANSYS CFX implement the phase transition from solid to liquid to allow for a gradual change in the geometry of the burr during melting, ie border, on which acts the heat flux? What happens to the fused metal in this problem is not considered.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Compressible Flow in Ansys CFX	bcheruk	CFX	15	July 6, 2017 06:30
Setting Pressure Boundary Conditions in ANSYS CFX Pre	saisanthoshm88	CFX	21	February 22, 2017 16:50
ANSYS CFX Tutorial	Rashid	CFX	25	December 20, 2012 01:22
"ANSYS CFX" and "CFX TascFlow"	ROOZBEH	CFX	2	December 13, 2005 01:37
CFX bought by Ansys - good or bad?!	Pete	CFX	38	February 21, 2003 07:34

April 2, 2014, 18:19		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,697 Rep Power: 143	CFX is a CFD solver, not a solid mechanics solver. Try ANSYS mechanical for that. In fact if the heat flux is constant then there is no fluids or heat transfer conponent to this so no reason to use a CFD software. So this model should be done entirely in FEA. Depending on what the material is you might also need to include phase transitions and that sort of stuff to be accurate - but that depends on how accurate you want to be.