BOUNDARY conditions

Ashwin k · May 20, 2014, 05:50

hello,
i m new to cfd. rit now im working for erosion analysis of the pump in CFX.
can anyone help me
1. how to implement material properties to the model which was imported from catia.
2. how to apply boundary conditions
here r the properties of the pump
working pressure of the pump- 400bar
inlet dia- 7mm
outlet dia- 2.8mm
roughness of the wall - 4.5 microns

Bazinga · May 20, 2014, 06:23

Dear Ashwin k,

you can create your own materials and also use some default materials when you set up your simulation in the preprocessor.

You can also set boundary conditions for the surfaces of your geometry in the preprocessor by rightclicking on them and add boundary conditions.

Ashwin k · May 20, 2014, 06:39

k.. what must be the inlet boundary condition according to my pump properties

Ashwin k · May 20, 2014, 06:44

whether i have to velocity or the pressure
in ansys tutorials there was a problem in which they specified velocity at the inlet and average static pressure at the outlet when i had given to my problem domain it didnt work.
velocity - 92mm/s
pump operates at pressure- 400 bar

May 20, 2014, 05:50	BOUNDARY conditions	#1
Ashwin k New Member Join Date: May 2014 Posts: 4 Rep Power: 12	hello, i m new to cfd. rit now im working for erosion analysis of the pump in CFX. can anyone help me 1. how to implement material properties to the model which was imported from catia. 2. how to apply boundary conditions here r the properties of the pump working pressure of the pump- 400bar inlet dia- 7mm outlet dia- 2.8mm roughness of the wall - 4.5 microns

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 08:38
Question about heat transfer coefficient setting for CFX	Anna Tian	CFX	1	June 16, 2013 07:28
symmetry boundary conditions in cfx	lost.identity	CFX	41	May 22, 2013 08:21
[Netgen] boundary conditions and mesh exporting	vaina74	OpenFOAM Meshing & Mesh Conversion	2	May 27, 2010 10:38
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 05:15

May 20, 2014, 06:23		#2
Bazinga Senior Member Join Date: Jun 2012 Location: Germany, Bochum Posts: 230 Rep Power: 16	Dear Ashwin k, you can create your own materials and also use some default materials when you set up your simulation in the preprocessor. You can also set boundary conditions for the surfaces of your geometry in the preprocessor by rightclicking on them and add boundary conditions.

May 20, 2014, 06:39		#3
Ashwin k New Member Join Date: May 2014 Posts: 4 Rep Power: 12	k.. what must be the inlet boundary condition according to my pump properties

May 20, 2014, 06:44		#4
Ashwin k New Member Join Date: May 2014 Posts: 4 Rep Power: 12	whether i have to velocity or the pressure in ansys tutorials there was a problem in which they specified velocity at the inlet and average static pressure at the outlet when i had given to my problem domain it didnt work. velocity - 92mm/s pump operates at pressure- 400 bar