Mesh refining using sphere of influence
2 Attachment(s)
Dear all
I am trying to refine mesh around the estimated transition (LSB) location around the thick aerofoil -S814 for the low Reynolds number flow. I had already created two spheres of influence as shown in the Figure attached, the element size are 0.00425 m and 0.00015 m for the bigger and smaller spheres. On top of these two spheres, I want to add an addition small sphere as shown in Figure with 0.000075 m of element size....However, the CFX has shown nothing changed from the original mesh (the two spheres) with no error messages and a green tick after it finish meshing. The local min size is set below the element size of the sphere..... Could anyone tell me how to solve this problem ? Thanks |
All times are GMT -4. The time now is 02:32. |