Ansys CFX Post

Ckern · June 20, 2014, 03:14

Hello,

I have a radial compressor with inlet,diffusor and volute,
and made planes in CFD Post with different radius=const. so long no problem,
now i want to unwind the planes, so that i can see die whole plane with radius=const, with circumference over die height of the plane or conversely, that i can see the plane as a plate.

Thank you for help.
Ckern

ghorrocks · June 21, 2014, 06:01

I do not think CFD-Post can do this. I would export the data in the plane and take it into tecplot, paraview or some other post pocessing package and do it there.

Meister · June 30, 2014, 08:34

Hi Christoph,

you should try the Turbo-mode. It is possible to do this there - the only problem is the definition of hub and shroud areas but it is possible and I did that already for a similar problem.

June 20, 2014, 03:14	Ansys CFX Post	#1
Ckern New Member Christoph Join Date: May 2014 Posts: 4 Rep Power: 11	Hello, I have a radial compressor with inlet,diffusor and volute, and made planes in CFD Post with different radius=const. so long no problem, now i want to unwind the planes, so that i can see die whole plane with radius=const, with circumference over die height of the plane or conversely, that i can see the plane as a plate. Thank you for help. Ckern

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Setting the desired Zoom level in ANSYS CFD Post for custom reports	shreyasr	CFX	1	July 11, 2013 01:57
Two way FSI post processing in CFX	ashli217	ANSYS	0	May 3, 2013 05:43
Ansys CFX Post Processing	rajeshfromindia	CFX	0	February 19, 2013 11:21
ANSYS Multi-physics and CFX coupling error	anujit	CFX	3	June 21, 2009 18:39
ANSYS CFX POST State file	Mechstud	CFX	1	June 22, 2007 14:59

June 21, 2014, 06:01		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,700 Rep Power: 143	I do not think CFD-Post can do this. I would export the data in the plane and take it into tecplot, paraview or some other post pocessing package and do it there.

June 30, 2014, 08:34		#3
Meister New Member Thomas Join Date: May 2014 Posts: 14 Rep Power: 11	Hi Christoph, you should try the Turbo-mode. It is possible to do this there - the only problem is the definition of hub and shroud areas but it is possible and I did that already for a similar problem.