[rainer_kit]

Hi,
I am currently running a simulation on the flow in porous media.
Right know I face quite strange effects when post processing my simulation.
I have boundary condition of
inlet: 5g/s a Fluid
outlet: static pressure : 101300Pa
Multiphase flow: begining: everything filled with Air, then Fluid gets filled inside cavity
Transient Simulation.

When I run the simulation for too long i get the error:
A wall has been placed at the following Domain Outlet to prevent flow inside...

If I run the simulation a bit shorter, so I stop before the error occurs, the pressure at the outlet is lower than the boundary pressure namely 83000Pa.

How is this possible? Any ideas how to prevent this?
I attach a picture of the solution a few timesteps before the error comes up.


Thank you for your help.

[evcelica]

First of all, you should be using 0 Pa at your outlet, and a reference pressure of 83000Pa. You are getting recirculation, extend your outlet further away from your hump, perhaps 20*h. When you stop it early the model is not converged and you are getting rubbish.
600 psi is a heck of a lot of pressure drop though....

[rainer_kit]

Thank you for the advice.

I am running a transient simulation. The main purpose is to detect the flow front, and the pressure in the cavity during the injection.

When I inject the Fluid at the inlet the Air which is in the cavity at the beginning is supposed to be pushed out of the cavity with pressure (outlet pressure =0 )

When running the simulation now I get negative values for pressure which in my opinion is physically impossible for am mass conservation point of view.

As the cavity just has a specific length I think I would change the results if i make it longer.

Tell me if i´m getting something wrong.

[ghorrocks]

Do you mean negative absolute pressure or negative pressure? Negative absolute pressure is a worry in most cases (but note in some extreme cases negative absolute pressure is possible and really does happen) but negative pressure is normal - it just means the pressure is less than your reference pressure.