2d regions that are used in more than one boundary condition

kg1913 · August 29, 2014, 12:18

This is might be very easy... (CFXPre)

I know that there are 2 regions used in more than 1 boundary condition. But for some reason, I can not remove or edit that boundary condition. It doesn't allow me to do anything in that BC

vahidk · March 11, 2017, 18:10

I have same problem. what I should do?

evcelica · March 14, 2017, 15:26

Can you split the boundary in the geometry if that is needed.

In Pre, you can go to edit >> Options >> general >. Auto generation >> and turn off automatic interfaces, then hit apply. Now you be able to delete it.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 08:38
thermal couple boundary condition between porous and fluid regions	atoof	OpenFOAM Programming & Development	2	June 7, 2017 20:44
Radiation interface	hinca	CFX	15	January 26, 2014 18:11
conjugate boundary condition	Daniel_Khazaei	OpenFOAM Programming & Development	0	December 31, 2013 14:11
An error has occurred in cfx5solve:	volo87	CFX	5	June 14, 2013 18:44

March 11, 2017, 18:10		#2
vahidk New Member vahid Join Date: May 2015 Posts: 2 Rep Power: 0	I have same problem. what I should do?

March 14, 2017, 15:26		#3
evcelica Senior Member Erik Join Date: Feb 2011 Location: Earth (Land portion) Posts: 1,196 Rep Power: 24	Can you split the boundary in the geometry if that is needed. In Pre, you can go to edit >> Options >> general >. Auto generation >> and turn off automatic interfaces, then hit apply. Now you be able to delete it.