 |
 |
 |
|
|
|
[Sponsors] | ||||
September 8, 2014, 05:35
|
meshing and named selection
|
#1 |
|
Member
aliali
Join Date: Apr 2014
Posts: 35
Rep Power: 12  |
I need to name a part of a face. I did it by imprinting my shape onto the face and put a name for it but when I want to mesh the face (mapped face meshing)
the edges that I imprinted onto the face cause I cant do it( I dont want to mesh the edges) and if I use virtual topology for that face, my named selection changes(form 3 faces turns to 2 faces). thanks |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] "The mesh file exporter does not support overlapping geometry in named selections" | blacksoil2012 | ANSYS Meshing & Geometry | 4 | October 30, 2015 10:27 |
| [DesignModeler] Named selections - is there a quick way to do it? | Marion | ANSYS Meshing & Geometry | 2 | May 24, 2013 10:05 |
| Named selection for internal face not appearing in CFX-Pre | francis1 | CFX | 4 | May 1, 2013 19:47 |
| [Workbench] Named selection for internal face not appearing in CFX-Pre | francis1 | ANSYS Meshing & Geometry | 0 | April 21, 2013 09:22 |
| [Other] Named selection in meshing. | rkmittal1108@gmail.com | OpenFOAM Meshing & Mesh Conversion | 0 | September 16, 2012 08:08 |
Linear Mode
