CFX Post Application error

Manchan · October 1, 2014, 15:55

I have completed the steady state simulation of cross flow turbine. But while opening the results, the following message shows.

CFD-Post Application Error

ERROR
Error reading file 'E:\ansys simulations\simulations\permanent\new\4\r 55 0.67_files\dp0\CFX\CFX\CFX_001.res':
Error reading number of domains (G/NZN).

Please help.

Opaque · October 1, 2014, 16:03

check your output control settings. Did you include the mesh ?

Manchan · October 1, 2014, 18:47

Quote:

Originally Posted by Opaque

check your output control settings. Did you include the mesh ?

No sir, the include mesh option was not checked. Is that the problem?

Thank you for your reply.

ghorrocks · October 5, 2014, 07:30

If you do not include the mesh then CFD-Post does not know the geometry you are modelling, so your file is invalid.

October 1, 2014, 15:55	CFX Post Application error	#1
Manchan New Member Manchan Tiwari Join Date: Sep 2013 Posts: 2 Rep Power: 0	I have completed the steady state simulation of cross flow turbine. But while opening the results, the following message shows. CFD-Post Application Error ERROR Error reading file 'E:\ansys simulations\simulations\permanent\new\4\r 55 0.67_files\dp0\CFX\CFX\CFX_001.res': Error reading number of domains (G/NZN). Please help.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CFX Pre & Post Startup Error	vigges	CFX	12	March 17, 2023 03:30
[OpenFOAM.org] compile error in dynamicMesh and thermophysicalModels libraries	NickG	OpenFOAM Installation	3	December 30, 2019 00:21
[swak4Foam] groovyBC: problems compiling: "flex: not found" and "undefined reference to ..."	sega	OpenFOAM Community Contributions	12	February 17, 2010 09:30
POSDAT problem	piotka	STAR-CD	4	June 12, 2009 08:43
DecomposePar links against liblamso0 with OpenMPI	jens_klostermann	OpenFOAM Bugs	11	June 28, 2007 17:51

October 1, 2014, 16:03		#2
Opaque Senior Member Join Date: Jun 2009 Posts: 1,804 Rep Power: 32	check your output control settings. Did you include the mesh ?

October 5, 2014, 07:30		#4
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	If you do not include the mesh then CFD-Post does not know the geometry you are modelling, so your file is invalid.