|October 15, 2014, 00:10||
Rigid body .out file
Join Date: Aug 2013
Posts: 37Rep Power: 5
I have done a simulation on a simple plate and have run the solution in cfx (out file could not be attached due to high memory). But in the result file the animation has to be shown. But the plate does not move on the influence of water inlet.
The out file seems to be ok for me as no error is showing there. If anyone can help me with this.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Swak4Foam funkyDoCalc with OF2.3 massflow||NiFl||OpenFOAM||11||November 1, 2016 07:43|
|what is swap4foam ??||AB08||OpenFOAM||28||February 2, 2016 02:22|
|patch error OF v2.2.2 mac||hewei||OpenFOAM Installation on Windows, Mac and other Unsupported Platforms||4||November 30, 2013 17:55|
|Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12||keepfit||OpenFOAM Paraview & paraFoam||60||September 18, 2013 03:23|
|DxFoam reader update||hjasak||OpenFOAM Post-Processing||69||April 24, 2008 01:24|