|
[Sponsors] |
October 15, 2014, 00:10 |
Rigid body .out file
|
#1 |
Member
shikha
Join Date: Aug 2013
Posts: 40
Rep Power: 12 |
Hello everyone,
I have done a simulation on a simple plate and have run the solution in cfx (out file could not be attached due to high memory). But in the result file the animation has to be shown. But the plate does not move on the influence of water inlet. The out file seems to be ok for me as no error is showing there. If anyone can help me with this. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] funkyDoCalc with OF2.3 massflow | NiFl | OpenFOAM Community Contributions | 14 | November 25, 2020 03:30 |
what is swap4foam ?? | AB08 | OpenFOAM | 28 | February 2, 2016 01:22 |
patch error OF v2.2.2 mac | hewei | OpenFOAM Installation | 4 | November 30, 2013 16:55 |
[OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12 | keepfit | ParaView | 60 | September 18, 2013 03:23 |
DxFoam reader update | hjasak | OpenFOAM Post-Processing | 69 | April 24, 2008 01:24 |