Flow over a fixed cylinder

mahdimazloom · October 16, 2014, 05:36

TUBES_CROSSFLOW_OVER_FIG2.jpg

I want to model transient cross-wise two-dimensional flow over a fixed cylinder.

Should I consider a turbulence model for the fluid for Re up to 20000?

Based on attached figure from "Blevins, Flow Induced Vibration, 1990"
vortex street transforms from laminar to fully turbulent for 150<Re<300000.
But boundary layer stay laminar in this range of Re.

If so which turbulence model should I use?

Meanwhile I'v tried no turbulence modelling and the results seem good regarding Strouhal number.

ghorrocks · October 16, 2014, 18:18

I would try the SST model in that range first, and if that seems to be giving you too much dissipation int he boundary layer then move to the gamma-theta turbulence transition model.

October 16, 2014, 05:36	Flow over a fixed cylinder	#1
mahdimazloom New Member Mahdi Mazloom Join Date: Jul 2014 Location: Mashhad - Iran Posts: 12 Rep Power: 11	TUBES_CROSSFLOW_OVER_FIG2.jpg I want to model transient cross-wise two-dimensional flow over a fixed cylinder. Should I consider a turbulence model for the fluid for Re up to 20000? Based on attached figure from "Blevins, Flow Induced Vibration, 1990" vortex street transforms from laminar to fully turbulent for 150<Re<300000. But boundary layer stay laminar in this range of Re. If so which turbulence model should I use? Meanwhile I'v tried no turbulence modelling and the results seem good regarding Strouhal number.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Issues on the simulation of high-speed compressible flow within turbomachinery	dowlee	OpenFOAM Running, Solving & CFD	11	August 6, 2021 06:40
Drag force coefficient too high for a flow past a cylinder using komega sst	Scabbard	OpenFOAM Running, Solving & CFD	37	March 21, 2016 16:16
benchmark: flow over a circular cylinder	goodegg	Main CFD Forum	12	January 22, 2013 11:47
1 Was FSI for a flow over a cylinder	vmlxb6	CFX	17	May 16, 2011 02:29
Moving a Cylinder in cross flow after solving Dynamics equations of motion	maruthamuthu_venkatraman	OpenFOAM	1	November 19, 2009 13:55

October 16, 2014, 18:18		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,692 Rep Power: 143	I would try the SST model in that range first, and if that seems to be giving you too much dissipation int he boundary layer then move to the gamma-theta turbulence transition model.