 |
 |
 |
|
|
|
[Sponsors] | ||||
December 22, 2014, 13:57
|
Create Part
|
#1 |
|
Member
Christian
Join Date: Sep 2013
Location: Germany
Posts: 88
Rep Power: 12  |
Hello everybody,
i made some surfaces in icem and seperate them in two parts. But i forgot to define a third part for a surface in icem. The surface is still in one of the two basic parts. Do i have to do a new mesh or can i edit it in cfx? |
|
|
|
|
|
December 22, 2014, 16:09
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,700
Rep Power: 143 |
You can access some mesh primitives in CFX-Pre, so if it is there you will not need to remesh. But if not then your only choice is to return to ICEM.
|
|
|
|
|
|
|
December 23, 2014, 05:20
|
|
#3 |
|
Member
Christian
Join Date: Sep 2013
Location: Germany
Posts: 88
Rep Power: 12 |
As always, thank you for your fast reply glenn ! :-)
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [GAMBIT] How to plot S pipe | mariam.sara | ANSYS Meshing & Geometry | 36 | November 7, 2013 15:22 |
| Create a multi-bosy part | 0906536m | FLUENT | 0 | September 16, 2013 06:27 |
| what boundary condition is proper for simulation of shock-tube low pressure part? | immortality | OpenFOAM Running, Solving & CFD | 0 | May 2, 2013 13:22 |
| Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
| Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
1Likes
Linear Mode
