|
[Sponsors] |
September 8, 2015, 10:53 |
Problems with DES Model in CFX, thanks
|
#1 |
New Member
陈思成
Join Date: Oct 2014
Posts: 7
Rep Power: 11 |
Hello.
I am using DES Models in CFX to simulate a centrifugal compressor with an impeller (9 main blades, 9 splitter blades) and a diffuser (16 blades). Concerning the number of the blades, for their ratio is not 1:1, should I compute the working condition of all passages, or can I only compute one passage to get the result. Also, I am wondering its requirement of the mesh. Thank you for your time, and I would be really grateful for your help. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFX multiphase flow model | aximefu | CFX | 24 | February 17, 2018 05:35 |
Wrong flow in ratating domain problem | Sanyo | CFX | 17 | August 15, 2015 06:20 |
Need Help to Enable Wall Boiling Model in CFX | cjhaw | CFX | 3 | September 26, 2013 09:40 |
How to use non-equilibrium thermal model for porous medium in Ansys CFX 13.0? | Chander | CFX | 3 | November 28, 2011 14:26 |
[ICEM] Proper way to name boundaries on 2D model for use in CFX? | RossFS | ANSYS Meshing & Geometry | 4 | November 10, 2011 02:38 |