 |
 |
 |
|
|
|
[Sponsors] | ||||
Out mass flow rate when using opening boundary condition |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 11, 2015, 10:51
|
Out mass flow rate when using opening boundary condition
|
#1 |
|
Senior Member
sluzzer
Join Date: Jul 2014
Posts: 146
Rep Power: 13  |
In an opening boundary condition, flow can enter in and also it can leave out..
Cfx considers whatever flow enters the domain as positive and whatever flow leaves as negative and gives the net flow rate when checked in cfdpost.... suppose If we want to know the mass flow out without considering the recirculation, I mean adding both out and whatever goes in by circulation, then is it possible to calculate? |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 06:45 |
| Volume flow rate boundary condition in OpenFOAM | mayank.dce2k7 | OpenFOAM Running, Solving & CFD | 13 | August 11, 2014 21:16 |
| Radiation interface | hinca | CFX | 15 | January 26, 2014 18:11 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 07:28 |
| Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 08:00 |
Linear Mode
