|
[Sponsors] |
September 21, 2015, 03:23 |
Object name problem for hostname
|
#1 |
New Member
Omar Osama Mohamed
Join Date: Nov 2014
Posts: 26
Rep Power: 11 |
Hi ,
i have read ANSYS manual and it says that the host name should 1.begins with letter 2.no underscores 3.no full stops I wonder if anyone cane help with that error ? the host name just contains dash '-' which should be acceptable. I didn't change anything in the hostinfo.ccl file because i don't have the authority to change it in the university. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
area does not match neighbour by ... % -- possible face ordering problem | St.Pacholak | OpenFOAM | 10 | February 7, 2024 21:50 |
problem in general moving object and collision modeling | Saeid | FLOW-3D | 6 | August 30, 2016 04:10 |
strange problem with data | seav | OpenFOAM Running, Solving & CFD | 0 | April 11, 2014 05:01 |
Is this the correct approach to my problem? (UDF for object in motion) | charlestan88 | Fluent UDF and Scheme Programming | 5 | October 27, 2013 06:09 |
CCL / Monitor Object Problem | James Date | CFX | 4 | September 29, 2010 02:23 |