|
[Sponsors] |
March 16, 2015, 00:53 |
POST Turbo set question
|
#1 |
New Member
Cafard
Join Date: Jun 2014
Posts: 29
Rep Power: 11 |
Hi,
CFD-POST.jpg this my radial inflow turbine simulation result in CFD POST Turbo-Blade to Blade,the left is blade and right is inducer,but actually the left should be inducer and right should be blade. How to change the location?? |
|
March 16, 2015, 03:41 |
|
#2 |
Senior Member
Thomas MADELEINE
Join Date: Oct 2014
Posts: 126
Rep Power: 11 |
that is something you should have set before your simulation... in CFD-Post I think it is a little bit late...
From my point of view, the best thing to do is open the CFX-Pre and set the inducer to your blade and the blade to your inducer. Then run only 1 iteration just to update the names. |
|
September 30, 2015, 02:11 |
|
#3 |
New Member
W Lorenz
Join Date: Sep 2013
Posts: 1
Rep Power: 0 |
Hi,
it is not necessary to change in Pre. You should initialize the volume in another order. The first the blade and 2nd the inducer. regards W Lorenz |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
a philosophy question about rotating-stationary interface of turbo machinery? | samane_81 | CFX | 0 | December 13, 2012 17:45 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
Question about post processing | qtian | OpenFOAM Post-Processing | 0 | July 24, 2007 12:44 |
Env variable not set | gruber2 | OpenFOAM Installation | 5 | December 30, 2005 04:27 |
How to set environment variables | kanishka | OpenFOAM Installation | 1 | September 4, 2005 10:15 |