Define Boundary conditions

raghulvr · October 15, 2015, 03:10

Hi guys,
Ibam analysing the flow-pressure characteristic of pressure control valve in CFX.
My question is how to define both
1.Static pressure
2.mass flow rate of fluid within one boundary itself(i.e inlet)
I tried to add both these input parameters within one boundary itselfitself.but option available do not facilitate this to be entered in one field.
Total pressure(static) and mass flow areare available as two separate options.
Can you help me out!
Thanks in Advance!!!

ghorrocks · October 18, 2015, 19:44

I should write an FAQ on this....

You cannot have a boundary with both velocity and pressure specified.

So, specify the pressure at the inlet and the flow rate (velocity) at the outlet. The flow rate at the outlet is the same as the inlet for a steady state flow.

October 15, 2015, 03:10	Define Boundary conditions	#1
raghulvr Member Rahul Join Date: Sep 2015 Posts: 39 Rep Power: 10	Hi guys, Ibam analysing the flow-pressure characteristic of pressure control valve in CFX. My question is how to define both 1.Static pressure 2.mass flow rate of fluid within one boundary itself(i.e inlet) I tried to add both these input parameters within one boundary itselfitself.but option available do not facilitate this to be entered in one field. Total pressure(static) and mass flow areare available as two separate options. Can you help me out! Thanks in Advance!!!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
Low torque values on Screw Turbine	Shaun Waters	CFX	34	July 23, 2015 08:16
GETVAR Error in Multiband Monte Carlo Radiation Simulation with Directional Source	silvan	CFX	3	June 16, 2014 09:49
Free surface boudary conditions with SOLA-VOF	Fan	Main CFD Forum	10	September 9, 2006 12:24
UDF FOR UNSTEADY TIME STEP	mayur	FLUENT	3	August 9, 2006 10:19

October 18, 2015, 19:44		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	I should write an FAQ on this.... You cannot have a boundary with both velocity and pressure specified. So, specify the pressure at the inlet and the flow rate (velocity) at the outlet. The flow rate at the outlet is the same as the inlet for a steady state flow.