[Shomaz ul Haq]

Dear all,

Hi. Hope all are well. I am doing parametric modeling and optmization in ANSYS Workbench. In project tab when I update Design of Experiments in Response Surface Optimization I get the following error.

"Update failed for the Design of Experiments component in Response Surface Optimization. 6 Design Points have failed to update and have been preserved in the project. From the Project Schematic, edit the Parameter Set cell to attempt a single Design Point update and review the detailed error messages."

Any idea why am I getting this error. Everything is correct in modeler, mesh, cfx-pre, solver, and cfd-post. Also there was no error when I manually changed the parameters. Would be grateful for help. Thanks.

[mariaCFD]

I'v been having the same problem, have you found a solution?

[alinik]

Hi,
did u find any solution?