Transition SST model error
 

Hello Everyone.
I got a problem which is transitional turbulence SST model error
Parallel run: Received message from slave
-----------------------------------------
Slave partition : 16
Slave routine : ErrAction
Master location : RCVBUF,MSGTAG=1012
Message label : 001100279
Message follows below - :

+--------------------------------------------------------------------+
| ERROR #001100279 has occurred in subroutine ErrAction. |
| Message: |
| Floating point exception: Overflow |
| |
| |
| |
| |
| |
+--------------------------------------------------------------------+

Parallel run: Received message from slave
-----------------------------------------
Slave partition : 16
Slave routine : ErrAction
Master location : RCVBUF,MSGTAG=1012
Message label : 001100279
Message follows below - :

+--------------------------------------------------------------------+
| ERROR #001100279 has occurred in subroutine ErrAction. |
| Message: |
| Stopped in routine FPX: C_FPX_HANDLER |
| |
| |
| |
| |
| |
+--------------------------------------------------------------------+

+--------------------------------------------------------------------+
| An error has occurred in cfx5solve: |
| |
| The ANSYS CFX solver exited with return code 1. No results file |
| has been created. |
+--------------------------------------------------------------------+

The error is shown by this.
I don't know how to solve this problem.
Also, if i do not use transition SST model, it is working.

Best Regards
JeongJu

FAQ: http://www.cfd-online.com/Wiki/Ansys...do_about_it.3F

So you clearly have a problem with the transitional turbulence model. That should give you some clue for where to look.

Thank you ghorrocks!