water hammer tests

bboynido · July 6, 2016, 12:48

Hello everyone

As part of the admission process for a master degree in one of the university, I was asked to simulate water hammer tests using Ansys Workbench. I am new to internal simulations, i am used to external simulations and i was wondering if anyone can help!!? is there any tutorials that can help running simulations with and without FSI ? how should i start ?

Below you will find the description of the tasks.

Thank you for your attention
Attached Files

ghorrocks · July 6, 2016, 20:06

The CFX tutorials which are installed with CFX are a good place to start. Then there are many more on the ANSYS Community website.

bboynido · July 6, 2016, 20:11

Thank you for your reply I will go through the tutorials and see what i can do

July 6, 2016, 20:06		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,869 Rep Power: 144	The CFX tutorials which are installed with CFX are a good place to start. Then there are many more on the ANSYS Community website. bboynido likes this.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Water hammer tests with and without FSI	bboynido	FLUENT	0	July 4, 2016 14:34
Getting the pressure waves in Fluent for a water hammer problem	teopetre	FLUENT	2	August 6, 2013 20:24
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 04:32
Terrible Mistake In Fluid Dynamics History	Abhi	Main CFD Forum	12	July 8, 2002 10:11
uptodate water distribution network	fredius,magige,tanzanian,(e.a)	Main CFD Forum	0	January 27, 2002 08:10

July 6, 2016, 20:11		#3
bboynido New Member Nader Khattabi Join Date: Mar 2016 Location: Tunisia Posts: 23 Rep Power: 10	Thank you for your reply I will go through the tutorials and see what i can do