license problem in simulation

aja1345 · September 10, 2016, 05:05

Hi,

I am running a turbine. When solution reach to about 300-400 iteration, I stop run and then i save. but when i again continue run, i have the following error! Why does this happen?

I am grateful that guide me about this case.

Best.

Aja

ghorrocks · September 10, 2016, 06:57

Because the license was available for your first run but was not available for the second run. Somebody else might have grabbed the license, the license server could be down, the license may have expired, the network connection to the license server could have gone down......

aja1345 · September 10, 2016, 08:49

Quote:

Originally Posted by ghorrocks

Because the license was available for your first run but was not available for the second run. Somebody else might have grabbed the license, the license server could be down, the license may have expired, the network connection to the license server could have gone down......

Thanks. But I didn't understand your means about "down"!

What is your exact meaning of "down" here?!

thanks

aja1345 · September 10, 2016, 08:51

This error happens just in a ...

September 10, 2016, 05:05	license problem in simulation	#1
aja1345 Senior Member Aja Join Date: Nov 2013 Posts: 496 Rep Power: 14	Hi, I am running a turbine. When solution reach to about 300-400 iteration, I stop run and then i save. but when i again continue run, i have the following error! Why does this happen? I am grateful that guide me about this case. Best. Aja Last edited by aja1345; September 12, 2016 at 16:06.

September 10, 2016, 06:57		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	Because the license was available for your first run but was not available for the second run. Somebody else might have grabbed the license, the license server could be down, the license may have expired, the network connection to the license server could have gone down...... aja1345 likes this.

September 10, 2016, 08:51		#4
aja1345 Senior Member Aja Join Date: Nov 2013 Posts: 496 Rep Power: 14	This error happens just in a ... Last edited by aja1345; September 19, 2016 at 04:55.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem in initializing transient simulation with a finer mesh	sidd	CFX	8	April 29, 2016 02:25
Contact simulation Problem	nguyenthanhctm	FLUENT	0	December 19, 2013 08:21
SimpleFoam convergence problem with really simple simulation	mayank.dce2k7	OpenFOAM Running, Solving & CFD	2	November 19, 2013 05:28
Low pressure de Laval simulation convergence problem	heksel8i	FLUENT	3	July 22, 2013 10:28
Heat Transfer simulation: No convergence problem	fiqs	CFX	2	April 21, 2010 15:47