Periodicity with different angles

andcfd · November 25, 2016, 07:57

Hello everybody,
I am working on a model of a turbomachine which has different periodicity along its axis, e.g periodicity 120° for the first section, 90° for the second section.
I modelled each section with its own periodicity, with periodicity interface for each one, with a general interface between them.
Is this a correct approach?

The massflow measured on both sides of the interface results the same, but to get the total massflow on 360° on one side the massflow has to be multiplied by 3, while on the other it has to be multplied by 4. Therefore the result on the whole section is different!

How can I set this problem?
Thank you

Opaque · November 25, 2016, 14:26

what pitch change model did you use across the interface ?

The pitch on either side is not the same based on your description; therefore, you should set a pitch change option different than None.

November 25, 2016, 07:57	Periodicity with different angles	#1
andcfd New Member Join Date: Nov 2014 Posts: 3 Rep Power: 11	Hello everybody, I am working on a model of a turbomachine which has different periodicity along its axis, e.g periodicity 120° for the first section, 90° for the second section. I modelled each section with its own periodicity, with periodicity interface for each one, with a general interface between them. Is this a correct approach? The massflow measured on both sides of the interface results the same, but to get the total massflow on 360° on one side the massflow has to be multiplied by 3, while on the other it has to be multplied by 4. Therefore the result on the whole section is different! How can I set this problem? Thank you

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] ICEM periodicity specification	robboflea	ANSYS Meshing & Geometry	18	November 11, 2014 14:51
[ICEM] Two kinds of periodicity in one project	PS_KA	ANSYS Meshing & Geometry	3	January 22, 2014 04:09
[ICEM] Hybrid Meshing and Periodicity	RalfBecker	ANSYS Meshing & Geometry	0	October 31, 2013 06:31
Flows at High Angles of Attack	Sarah C.	FLUENT	2	March 18, 2009 07:39
Periodicity in CFX	Sam S	CFX	2	August 27, 2007 00:59

November 25, 2016, 14:26		#2
Opaque Senior Member Join Date: Jun 2009 Posts: 1,803 Rep Power: 32	what pitch change model did you use across the interface ? The pitch on either side is not the same based on your description; therefore, you should set a pitch change option different than None.