CAB model activation

ibadullah safdar · January 23, 2017, 09:29

dear all I am working on venturi scrubber. I need to know about how to activate CAB model to see the droplet formation inside venturi scrubber.
I have three phases (air, water and particles). Air is taken as continuous phase. water is taken as dispersed fluid where particles are considered as particle transport solid. I have to see the droplet formation when air strikes water. In most of paper I have seen CAB model was used but i am unable to see that effect. I have selected the CAB mode in air/particle fluid specific model tab but did not see any effect in results. If anyone knows I shall be very thankful and God bless to him.
Thank you.

Mu_CFD · January 27, 2019, 08:38

My friend Ibadullah. I'm studying the same problem (Venturi scrubber with tree phases - air, water and particles). Were you able to activate CAB model to see dropler formation?

Could you explain for me how you did this?

THX!

January 23, 2017, 09:29	CAB model activation	#1
ibadullah safdar New Member Ibadullah Join Date: Jan 2016 Posts: 21 Rep Power: 11	dear all I am working on venturi scrubber. I need to know about how to activate CAB model to see the droplet formation inside venturi scrubber. I have three phases (air, water and particles). Air is taken as continuous phase. water is taken as dispersed fluid where particles are considered as particle transport solid. I have to see the droplet formation when air strikes water. In most of paper I have seen CAB model was used but i am unable to see that effect. I have selected the CAB mode in air/particle fluid specific model tab but did not see any effect in results. If anyone knows I shall be very thankful and God bless to him. Thank you.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wrong flow in ratating domain problem	Sanyo	CFX	17	August 15, 2015 07:20
Error in Two phase (condensation) modeling	adilsyyed	CFX	15	June 24, 2015 20:42
Is it possible to model natural convection in a 2D horizontal model in fluent	caitoc	FLUENT	1	May 5, 2014 14:32
manualInjection model in sprayFoam	Mentalo	OpenFOAM Running, Solving & CFD	1	April 2, 2014 10:29
Advanced Turbulence Modeling in Fluent, Realizable k-epsilon Model	Jonas Larsson	FLUENT	5	March 13, 2000 04:27

January 27, 2019, 08:38		#2
Mu_CFD New Member Join Date: Feb 2017 Posts: 9 Rep Power: 10	My friend Ibadullah. I'm studying the same problem (Venturi scrubber with tree phases - air, water and particles). Were you able to activate CAB model to see dropler formation? Could you explain for me how you did this? THX!