|
[Sponsors] |
February 24, 2000, 03:54 |
Dumping wall shear stress
|
#1 |
Guest
Posts: n/a
|
Hello,
I am intending to write the wall heat flux and wall shear stresses in CFX4.2 to a seperate file via Userfortran routines, but I cannot find the variables specifying these values. I mean these values are written into the default *.fo file, but is there a way to get hold of the values and write them to a seperate file? Cheers Fabian |
|
February 29, 2000, 10:55 |
Re: Dumping wall shear stress
|
#2 |
Guest
Posts: n/a
|
You should be able to find the variables you are looking for in usrdmp.f. I have used the file for accessing the convective and radiative heat flux, so I believe you can find the wall shear stresses as well.
Regards Jan |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 04:32 |
relationship between wall shear stress and TKE | winter | FLUENT | 0 | December 11, 2007 18:11 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 06:12 |
Re: About wall shear stress | Mike | FLUENT | 9 | November 17, 2003 15:41 |
Specifying shear stress on wall in 5.5.1 | michael rasmussen | CFX | 1 | May 19, 2003 10:49 |