Problem with parameters
Hey, I've been studing the mesh of a geometry and after some design point that I've created it starts failing.
the following message appears: Update failed for the Design of Experiments component in Response Surface. 5 Design Points failed to update and have been preserved in the project. From the Project Schematic, edit the Parameter Set cell to attempt a single Design Point update and review the detailed error messages. and at each design point this message appears Update of the Solution component in CFX for Design Point 13 failed: The solver failed with a non-zero exit code of : 2 thanks |
You will have to open the output file of those runs to see what really happened. The output file gives more useful error messages (most of the time).
|
how do I get to it?
inside of CFX folder, and then..? |
There probably is a way to get at it inside workbench but I find that a bit painful. So I get it out of the workbench project directory. Just have a look in the project directory and you should find it soon enough.
|
All times are GMT -4. The time now is 03:27. |