 |
 |
 |
|
|
|
[Sponsors] | ||||
March 6, 2017, 23:33
|
Wind turbine Blade modeling
|
#1 |
|
New Member
Gideon
Join Date: Mar 2017
Posts: 3
Rep Power: 10  |
Hello, I am new here, and I am trying to use the Blade Gen on Ansys to model a wind turbine blade, but I don't know how to start.Secondly,am I using the right tool to model the blades. Thank you.
|
|
|
|
|
|
March 7, 2017, 02:16
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 18,011
Rep Power: 146 |
Yes, bladegen sounds like a good tool to model the blades.
For tutorials on bladegen and all other ANSYS products go to the ANSYS customer website. |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to run a wind turbine blade simulation | gerritgroot | SU2 | 6 | February 8, 2019 15:44 |
| wind turbine blade flow simulation | rsskarthikeyan | FLUENT | 0 | May 27, 2015 06:40 |
| 3D wind turbine blade analysis | mrswordf1sh | FLUENT | 0 | April 4, 2015 21:17 |
| question about wind turbine blade geometry in Ansys | afshar6263 | ANSYS Meshing & Geometry | 0 | October 5, 2014 23:42 |
| Can I use Turbogrid to mesh a wind turbine blade? | Henry Liu | CFX | 10 | November 10, 2011 06:41 |
Linear Mode
