Home > Forums > Software User Forums > ANSYS > CFX

Problem with Creating Inflation (Only Edge Selection)

Mark Forums Read

Reply

Search this Thread

March 9, 2017, 17:10	Problem with Creating Inflation (Only Edge Selection)	#1
Towe91 New Member Join Date: Mar 2017 Posts: 4 Rep Power: 10	Hey Everyone! I have a problem with creating Inflations in Ansys 17.2. I created a heat exchanger and it worked perfectly but now I have the same type of Geometry and I changed basically the scale of the geometry and now I cannot create an inflation because when I insert it and I want to choose my Named Selection in the drop down it wont let me. And if I want to do it with geometry instead I can only select Edges... I am really stuck in this problem and I hope somebody can help me! Thanks!

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[SOWFA] NREL SOWFA ABLTerrainSolver tutorial problem	cico0815	OpenFOAM Community Contributions	36	February 3, 2022 12:54
[Commercial meshers] Mesh conversion problem (fluent3DMeshToFoam)	Aadhavan	OpenFOAM Meshing & Mesh Conversion	2	March 8, 2018 02:47
[GAMBIT] GAMBIT edge problem	SJD	ANSYS Meshing & Geometry	4	February 26, 2014 16:56
[ICEM] low edge criterion value problem	mraxx	ANSYS Meshing & Geometry	6	April 30, 2013 10:03
[DesignModeler] Creating a blunt trailing edge from collapsed leading edge	gmd	ANSYS Meshing & Geometry	0	March 2, 2012 10:48

All times are GMT -4. The time now is 22:50.