Cannot change Specific Heat Capacity option to NASA polynomials in CFX 14.5.7

khedar · March 11, 2017, 04:42

Hi, I need to use temperature dependent Cp(specific heat capacity) for my simulation. But in the material properties, the only option I get is "Value". I read the modelling guide and it says that there should be other options as well. Is this some version issue?

Thanks

highorder_cfd · March 13, 2017, 10:36

Can you not set an expression there?

Opaque · March 13, 2017, 13:06

If I recall correctly, the NASA and/or Zero Pressure Polynomials options are ONLY allowed for ideal gas materials.

Is you equation of state Ideal Gar, or constant density material ?

khedar · March 15, 2017, 09:43

I am using ideal gas but still cannot see the option. Finally I did using expressions. Thanks guys for the help

March 11, 2017, 04:42	Cannot change Specific Heat Capacity option to NASA polynomials in CFX 14.5.7	#1
khedar Senior Member khedar Join Date: Oct 2016 Posts: 111 Rep Power: 11	Hi, I need to use temperature dependent Cp(specific heat capacity) for my simulation. But in the material properties, the only option I get is "Value". I read the modelling guide and it says that there should be other options as well. Is this some version issue? Thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Setting the height of the stream in the free channel	kevinmccartin	CFX	12	October 13, 2022 22:43
Difficulty in calculating angular velocity of Savonius turbine simulation	alfaruk	CFX	14	March 17, 2017 07:08
Multiphase flow - incorrect velocity on inlet	Mike_Tom	CFX	6	September 29, 2016 02:27
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 04:32
Constant velocity of the material	Sas	CFX	15	July 13, 2010 09:56

March 13, 2017, 10:36		#2
highorder_cfd Member Join Date: Jan 2015 Posts: 63 Rep Power: 12	Can you not set an expression there?

March 13, 2017, 13:06		#3
Opaque Senior Member Join Date: Jun 2009 Posts: 1,938 Rep Power: 34	If I recall correctly, the NASA and/or Zero Pressure Polynomials options are ONLY allowed for ideal gas materials. Is you equation of state Ideal Gar, or constant density material ?

March 15, 2017, 09:43		#4
khedar Senior Member khedar Join Date: Oct 2016 Posts: 111 Rep Power: 11	I am using ideal gas but still cannot see the option. Finally I did using expressions. Thanks guys for the help