|May 16, 2001, 22:36||
Roughness and Turbulent multiplier
There is a problem about turbulent multiplier in USRWTM. In USRWTM user must set TMULT. I want to know how will I set this? In the solver manual(CFX 4.2) ROUGHNESS is set 1.0 (as a default) under the subcommand WALL BOUNDARIES. Could anyone tell me about this? Actually if it is the roughness factor, then its ok, but if it is the roughness height, I want to know the its unit.
Any suggestion about this will be appreciated.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Laminar flow and wall roughness||junbbung||FLUENT||1||December 2, 2012 06:57|
|Roughness in turbulent pipe flow||1000sh||Main CFD Forum||3||April 11, 2010 09:00|
|Roughness in Turbulent Pipe Flow||1000sh||FLUENT||2||April 11, 2010 05:55|
|wall roughness with SST turbulence model in CFX10||Vincent||CFX||7||September 10, 2007 16:49|
|FRICTION FACTOR TURBULENT PIPE and ROUGHNESS||beginner||FLUENT||1||July 30, 2007 15:16|