|
[Sponsors] |
August 3, 2001, 11:08 |
explosion using laminar flame model
|
#1 |
Guest
Posts: n/a
|
Hi, everybody. I am working on an explosion project. The explosion occurs in a vessel filled with premixed fuel-air gas mixture, and is triggered by an electrical spark. I am using the laminar flame model provided in CFX 4.3 to simulate the deflagration. My question is how I can go about to determine the parameters needed in laminar flame model in terms of different fuels. These parameters include quenching limit, flame width, ignition threshold, dtbmax, ignition length, ignition duraiton, etc.
Thirsty for hints. Thanks in advance. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
about Subgrid-scale model | impecca | OpenFOAM Running, Solving & CFD | 4 | December 20, 2013 11:36 |
How to model laminar zones? | sachin | OpenFOAM | 1 | February 12, 2011 10:07 |
Laminar model - Need some urgent help | amoolraina | FLUENT | 0 | September 5, 2010 01:15 |
Laminar flow in species transport model? | Neha Rao | FLUENT | 7 | February 25, 2006 03:23 |
Looking for Laminar Flame Codes | John | Main CFD Forum | 0 | September 17, 2005 20:13 |