|
[Sponsors] |
September 21, 2001, 01:10 |
Heat model in multiphase
|
#1 |
Guest
Posts: n/a
|
Dear all, I try to sim. heat transfer of solid in liquid phase flow in straigth pipe. When i used multiphase option, there is no option of heat model/thermal...to set the temp. at boundary/inlet. that if difference from 1 phase option. Then i try to used Fluid dependece ...option and specify the value of Temp. of solid and liquid in fluid (isothermal option). But ofter simulation, both temp. of solid and liquid are the same value that I inputed it. Why there is no temp. change of both phase . Please help me suggestion. Thank you
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Multiphase model in Fuel Cell module | E-Font | FLUENT | 0 | March 9, 2011 14:44 |
question about Heat transfer between two phases with VOF model | sooroo3 | FLUENT | 0 | February 15, 2011 03:24 |
Water vapour condensation in CFX-5.7.1 | hdj | CFX | 1 | November 27, 2005 07:15 |
is there heat transfer option in multiphase model | gayaz | FLUENT | 1 | July 16, 2003 11:13 |
Multiphase Mixture Model fluent5.4 | Julia Kullmann | FLUENT | 0 | March 9, 2001 05:13 |