Issued with CFX5.4

November 12, 2001, 07:39

Hi CFX 5.4 users, I have to model a second domain which is fitting as the outlet of domain 1. I have run CFX for my first domain and result is available. Now I would like to map the velocity and temperature from the outlet of first domain to second model inlet.Is there any method available with CFX 5.4. (I am bit concerned about using Equation fit as it may approximate results)

Thanks for your time Veebs

November 13, 2001, 21:49

Veebs,

This can be done in CFX-5.5. Mass shipment is scheduled for the end of November.

November 12, 2001, 07:39	Issued with CFX5.4	#1
VEEBS Guest Posts: n/a	Hi CFX 5.4 users, I have to model a second domain which is fitting as the outlet of domain 1. I have run CFX for my first domain and result is available. Now I would like to map the velocity and temperature from the outlet of first domain to second model inlet.Is there any method available with CFX 5.4. (I am bit concerned about using Equation fit as it may approximate results) Thanks for your time Veebs

November 13, 2001, 21:49	Re: Issued with CFX5.4	#2
Andrew Krucker Guest Posts: n/a	Veebs, This can be done in CFX-5.5. Mass shipment is scheduled for the end of November.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Warning from checkMesh is this serious	hsieh	OpenFOAM Running, Solving & CFD	9	April 27, 2022 10:45
Cannot find file points	derath	OpenFOAM Running, Solving & CFD	1	May 4, 2007 12:04