Post processing display problem
 

Hi,

I have just recently started using cfx 5.5 and experiencinga few problems. I have drawn simple geometry's in buildand then run solver and got results. I then go intopost processor to load up data, it sometimes loads to 75% and at other times it doesn't load anything. I ampretty sure it is a displaying graphics probelms. Has anyone experienced anything similar to this or have any ideas how I could overcome this.

Jennifer

Re: Post processing display problem
 

May the problem be caused by graphic card driver. Try to use windows2000. May the problem be solved.

Re: Post processing display problem
 

Had a similar problem particularly on vector plots, and new graphics(meaning better)card fixed it immediately