|
[Sponsors] |
February 6, 2002, 05:20 |
error
|
#1 |
Guest
Posts: n/a
|
Hi
I have got the following error coming up when I try to create/surface/trimmed. ''curves to be chained are not contiguous due to a gap of 0. The point of discontinuity has been marked'' What does this mean? Can anyone help? Jennifer |
|
February 7, 2002, 08:55 |
Re: error
|
#2 |
Guest
Posts: n/a
|
Hi Jennifer, this usually means that there's a gap in your curves. There are usually more than one way to create things in Build, and sometimes one option works better than another. Have you already chained your outer and inner curves ?? if so did you pick the edges of a surface to create your chained curve or just explicit curves. Try one or the other. If you still can't creat a chained curve then use show/point/location to check that the end points of curves match up, or even zoom right in to the ends of the curves to check they exist at the same location (use the zoom + and - buttons to get real close). Any other questions just email me, good luck Stuart
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
c++ libraries and solver compiling | vaina74 | OpenFOAM Installation | 13 | February 3, 2012 17:43 |
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 20:30 |
DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |
user defined function | cfduser | CFX | 0 | April 29, 2006 10:58 |