 |
 |
 |
|
|
|
[Sponsors] | ||||
Problem with flowpaths for blade and spliter - turbogrid |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 28, 2017, 14:28
|
Problem with flowpaths for blade and spliter - turbogrid
|
#1 |
|
New Member
Pawel
Join Date: May 2017
Posts: 1
Rep Power: 0  |
Hi everyone,
I've got a problem with modeling (DesignModeler) the centrifugal compressor with blades and spliters. When I create flowpath only for blade there's no problem with it, but when I try to add another one for spliter the error appears. When I try to do this different way - ExportPoints for spliter on the blade's flowpath, it doesn't work as well. What method is correct? |
|
|
|
|
|
| Tags |
| exportpoints, flowpath, spliter |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [TurboGrid] Problem with turbogrid | newbie384 | ANSYS Meshing & Geometry | 1 | February 10, 2014 01:01 |
Linear Mode
