Cavitation in pump-model test

March 27, 2002, 08:59

hi all I would like to simulation cavitation in end suction centrifugal pump and axial flow pump[using CFX Tasflow2.11.01], but I don't have result from model test. Wher's source that I can get it, from book, website...? Help me please. Regards

April 5, 2002, 15:11

First thing to know is that the cavitation model in TASCflow does not permit simulate the real (physical) behavior of sheet cavitation encountered in pumps. THe real phenomenon is much more complicated that simply putting vapor pressure all around.

A good start for you would be the thesis of Hirschi of the EPFL (lmhwww.epfl.ch). There is a lot of other interesting stuff there on the cavitation subject (experimental and numerical) including my thesis ;-).

Best regards,

March 27, 2002, 08:59	Cavitation in pump-model test	#1
opt Guest Posts: n/a	hi all I would like to simulation cavitation in end suction centrifugal pump and axial flow pump[using CFX Tasflow2.11.01], but I don't have result from model test. Wher's source that I can get it, from book, website...? Help me please. Regards

April 5, 2002, 15:11	Re: Cavitation in pump-model test	#2
Jean-François Caron Guest Posts: n/a	First thing to know is that the cavitation model in TASCflow does not permit simulate the real (physical) behavior of sheet cavitation encountered in pumps. THe real phenomenon is much more complicated that simply putting vapor pressure all around. A good start for you would be the thesis of Hirschi of the EPFL (lmhwww.epfl.ch). There is a lot of other interesting stuff there on the cavitation subject (experimental and numerical) including my thesis ;-). Best regards,

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Use of k-epsilon and k-omega Models	Jade M	Main CFD Forum	40	January 27, 2023 07:18
Advice about CEV cavitation model	Matthieu	CFX	1	October 27, 2018 10:00
about Subgrid-scale model	impecca	OpenFOAM Running, Solving & CFD	4	December 20, 2013 10:36
Re: Reference pressure for Cavitation model	CFD USER	CFX	5	June 3, 2012 07:01
Surface roughness setting for a model in wind tunnel test section	Sharon	CFX	12	March 31, 2009 13:09