|
[Sponsors] |
June 8, 2002, 07:31 |
Meshing error
|
#1 |
Guest
Posts: n/a
|
Hi I have imported a iges file into mesh only mode. But when I try to mesh I get the following error:
Fatal Error: Face evaluation failed Error: ------ face evaluation failed error status code: 2 Surface 2187 Does anyone have an idea ??? Thanx. regards Peter |
|
June 10, 2002, 07:08 |
Re: Meshing error
|
#2 |
Guest
Posts: n/a
|
hi
there is one way to eliminate this,use the parasolid otion while exporting ,and if you are not able to do this then while expoting to iges check on the tolerance and then try to increase it by a tenth, but I'd say parasolid is any day a better choice. henry |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
Compile problem | ivanyao | OpenFOAM Running, Solving & CFD | 1 | October 12, 2012 09:31 |
compile errors of boundary condition "expDirectionMixed" | liying02ts | OpenFOAM Bugs | 2 | February 1, 2010 20:11 |
Problems of Duns Codes! | Martin J | Main CFD Forum | 8 | August 14, 2003 23:19 |
error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 15:16 |