|
[Sponsors] |
July 11, 2002, 05:17 |
Support Level
|
#1 |
Guest
Posts: n/a
|
My company is just about to start using CFX, could anyone tell me what the level of support is like with this company?
|
|
July 11, 2002, 05:25 |
Re: Support Level
|
#2 |
Guest
Posts: n/a
|
The UK support is fantastic - even if they don't have an immediate answer to your question, they sound great on the phone!
|
|
July 11, 2002, 05:40 |
Re: Support Level
|
#3 |
Guest
Posts: n/a
|
Sounds good. Met some of there technical people on a recent course, and they seemed pretty knowlegable, but was unsure how quick they were to respond, generally is it same day/next day?
|
|
July 11, 2002, 10:37 |
Re: Support Level
|
#4 |
Guest
Posts: n/a
|
Within a day in general
|
|
July 12, 2002, 02:44 |
Re: Support Level
|
#5 |
Guest
Posts: n/a
|
Usually, they respond the same day or at least the next day. For difficult questions they frequently ask the specialists around and then you get an updated answer within one or two days.
Astrid |
|
July 12, 2002, 06:42 |
Re: Support Level
|
#6 |
Guest
Posts: n/a
|
Sounds pretty good - thanks for the info.
|
|
July 12, 2002, 10:20 |
Re: Support Level
|
#7 |
Guest
Posts: n/a
|
I hear the support is run by the chuckle brothers! (allegedly of course)
|
|
July 15, 2002, 09:01 |
Re: Support Level
|
#8 |
Guest
Posts: n/a
|
I have to agree with the comments above, The support is ment to be the best out of all three of the major three General CFD Codes. If found they have always been veery helpfull and happy to answer any question, however simple or basic the question is, without making you feel little. Bob
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 12:41 |
[snappyHexMesh] sMH refinement level | subhkirti | OpenFOAM Meshing & Mesh Conversion | 0 | October 13, 2010 04:10 |
critical error during installation of openfoam | Fabio88 | OpenFOAM Installation | 21 | June 2, 2010 03:01 |
[snappyHexMesh] snappyHexMesh - Refinement Level | andrea.pasquali | OpenFOAM Meshing & Mesh Conversion | 5 | February 8, 2010 03:08 |
Problems in compiling paraview in Suse 10.3 platform | chiven | OpenFOAM Installation | 3 | December 1, 2009 07:21 |