|
[Sponsors] |
July 25, 2017, 06:31 |
Elapsed time as outout parameter
|
#1 |
New Member
Jacob Mannhardt
Join Date: Jun 2017
Posts: 2
Rep Power: 0 |
Hey guys,
I was wondering if I could define the elapsed time of a simulation as an output parameter. It is quite annoying to select the current DP and switch to the monitors every single time for every single DP. Cheers Jacob |
|
July 26, 2017, 02:56 |
|
#2 |
Senior Member
Maxim
Join Date: Aug 2015
Location: Germany
Posts: 415
Rep Power: 12 |
"Time" is CFX output parameter that you can work with. Check the manual. You can extract that with cfx5mondata via command line as well if needed.
|
|
Tags |
cfd post, output parameters, solver, time |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[General] Extracting ParaView Data into Python Arrays | Jeffzda | ParaView | 30 | November 6, 2023 21:00 |
[Other] Contribution a new utility: refine wall layer mesh based on yPlus field | lakeat | OpenFOAM Community Contributions | 58 | December 23, 2021 02:36 |
AMI speed performance | danny123 | OpenFOAM | 21 | October 24, 2020 04:13 |
pressure in incompressible solvers e.g. simpleFoam | chrizzl | OpenFOAM Running, Solving & CFD | 13 | March 28, 2017 05:49 |
plot over time | fferroni | OpenFOAM Post-Processing | 7 | June 8, 2012 07:56 |