Error #001100279
 

Does anyone know what does the error below refer to ?
I obtained this error when I have added an initial file to start the simulation with Cavitation on.
If I don't do this, I don't have the error ...

Parallel run: Received message from slave
-----------------------------------------
Slave partition : 2
Slave routine : ErrAction
Master location : Message Handler
Message label : 001100279
Message follows below - :

+--------------------------------------------------------------------+
| ERROR #001100279 has occurred in subroutine ErrAction. |
| Message: |
| Stopped in routine ReadLong |
| |
| |
| |
| |
| |
+--------------------------------------------------------------------+

+--------------------------------------------------------------------+
| ERROR #001100279 has occurred in subroutine MESG_RETRIEVE. |
| Message: |
| Stopping the run due to error(s) reported above |
| |
| |
| |
| |
| |
+--------------------------------------------------------------------+

Can you post your .out file please.

Cavitation (and phase change) is notoriously difficult to get right.

I would do this:
1. make sure you're using a sensible initial solution
2. double check all your cavitation physics
3. double check your mesh
4. double check your time step
5. begin your cavitation simulation as a homogeneous multiphase simulation, only switching to inhomogeneous at a later stage
6. start the simulation off using relaxed numerics (upwind)