Home > Forums > Software User Forums > ANSYS > CFX

Convergence problem using crank nicolson method

Mark Forums Read

Reply

Search this Thread

September 17, 2002, 18:17	Convergence problem using crank nicolson method	#1
Carlos Gonzalez Guest Posts: n/a	The system starts ok but after a few time steps it diverges and stops iterating.

September 24, 2002, 17:52	Re: Convergence problem using crank nicolson metho	#2
Luis Bustamante Guest Posts: n/a	tienes que empezar de nuevo y trabajar con mas esfuerzo y dedicacion

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Continuity eq convergence problem	carno	FLUENT	4	February 8, 2008 05:04
Convergence Problem	Johnny B	FLUENT	5	November 4, 2003 17:01
convergence problem	Trushar	Phoenics	5	August 28, 2002 00:40
Convergence problem when ustructured mesh is used.	SangJin Ryu	Siemens	3	October 5, 2000 21:26
convergence problem with SIMPLER	NURAY KAYAKOL	Main CFD Forum	1	February 24, 1999 14:43

All times are GMT -4. The time now is 08:58.