|
[Sponsors] |
October 14, 2002, 22:54 |
A simple question!
|
#1 |
Guest
Posts: n/a
|
Hello everyone:
I am using cfx-tascflow 2.10 to solve a very simple example(on axis compressor).The boundary conditions come from the experimental data. I found it was difficult to converge when the mesh (near the blade surface)become dense and the grid size exceeded 400000. I think some parameters set maybe undesirable. But I don¡¯t know the actual reasons. Thanks! gracesky |
|
October 19, 2002, 08:38 |
Re: A simple question!
|
#2 |
Guest
Posts: n/a
|
If you can get converged solution at coarse mesh.You can do at other circumstance. You can try set the Dtime smaller and change initial.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Simple Outlet Question | m.nichols19 | OpenFOAM | 3 | June 25, 2010 02:44 |
Simple Question Regarding Symmetry Planes | Atella | CFX | 3 | April 11, 2010 07:44 |
Simple Question Regarding Symmetry Planes | Atella | Main CFD Forum | 0 | April 9, 2010 11:58 |
Question of Anil Date's SIMPLE method | universez | Main CFD Forum | 0 | November 18, 2009 21:12 |
Simple Question Regarding Continuity Closure | RC | FLUENT | 2 | March 25, 2004 06:30 |