Home > Forums > Software User Forums > ANSYS > CFX

Modeling Rotor/Stator machine via Tascflow

Mark Forums Read

Reply

Search this Thread

January 8, 2003, 06:18	Modeling Rotor/Stator machine via Tascflow	#1
Kirill Guest Posts: n/a	Dear all! When modeling Rotor/Stator machine via Tascflow. How calculate mass flow rate if both inlet and outlet boundary conditions type is Pressure? Thanks in advance. Regards

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
May Focus Area: Turbulence Modeling	Jonas Larsson	CFD-Wiki	0	May 2, 2006 12:48
Modeling Flow/Saturation/Absorption in Fibers	Gene Dougherty	Main CFD Forum	0	June 6, 2003 15:49
Solid Modeling	Chris	Main CFD Forum	10	July 2, 2002 08:12
CFD Modeling of Two-phase Flow in Small Dia.Tubes	Eric Poindexter	Main CFD Forum	2	September 22, 2000 10:21
Extrusion Modeling	Elliot Schwartz	Main CFD Forum	1	September 11, 1998 20:08

All times are GMT -4. The time now is 22:02.