How to specify a patch on a small hole -- CFD Online Discussion Forums

January 28, 2003, 05:26	How to specify a patch on a small hole	#1
allegro Guest Posts: n/a	Hi, everyone. My calculation involve a very small hole of diameter 1.5mm on a wall of size 0.3m. Initially I specified a patch of name INLET2 on the surface of hole using CFX4.3 Build, but the patch did not appear in the generated .geo file. I must specify some inlet condition in this hole, how to create a patch in this case? Thanks a lot.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Using starToFoam	clo	OpenFOAM Meshing & Mesh Conversion	33	September 26, 2012 04:04
[Other] StarToFoam error	Kart	OpenFOAM Meshing & Mesh Conversion	1	February 4, 2010 04:38
CheckMeshbs errors	ivanyao	OpenFOAM Running, Solving & CFD	2	March 11, 2009 02:34
[Gmsh] Import gmsh msh to Foam	adorean	OpenFOAM Meshing & Mesh Conversion	24	April 27, 2005 08:19
Multicomponent fluid	Andrea	CFX	2	October 11, 2004 05:12

All times are GMT -4. The time now is 07:34.