How Can I put inlet condition by the mass flux unit kg/m2 s
Hello Everyone,
My inquiry is: Is there any option to put the mass flux unit kg/m2 s as a inlet condition in CFX? Thanks for advance. |
Um, yes. Can I ask that you check the documentation before you ask questions like this in future? A minute reading the documentation would answer this question yourself.
|
Dear sir,
Yes, I checkd the modeling section in CFX. Here I can see the mass flow rate unit is kg/s, but I want to mass flus kg/m2 s for simulation the liquid to steam phase change by boiling. |
CFX has CEL to handle simple expressions like this. You just say something like MassFlowRate = MassFlux*area()@Inlet.
|
Thank you sir
|
All times are GMT -4. The time now is 07:27. |